Thermal shrinking machine time is not used, how to identify whether available

2019-01-28

Is a lot of companies will have this kind of situation, there will be a long time with no heat shrinking machine, then prepare to use, we must check the parts have clear without damage to equipment, and put into use again, if you don't check work directly, may cause some unnecessary loss, so how to identify whether the machine is available?See below:

1.Check the line safety

Shrinking machine first before use control panel to open it to check the circuit damage, factory workshop Canon often appear some kind of small rats killed the machine internal wire pests happen, for a long time not to use is to let the placement machine become the main object of erosion so the circuit integrity of the check and each process is particularly important to the power on.

2.Reconnaissance heating process

The heating process is the most important part of the thermal shrinking machine, which is mainly to heat the plastic film to fit on the product.

3.Check the cooling steps

After the heating treatment of the plastic film, an instant cooling is needed to prevent the package from being oxidized and thus deformed. The "health" of the air blower and whether it can operate normally are very important.Very warm heating will make the plastic film extremely easy to be damaged, the wind power of the wind tube will make the plastic film surface is not smooth or even blown, too small and not to the role of instant cooling.Checking the power supply and rotational speed temperature of the cooling process of the electric air duct is the key to checking the cooling process of the thermal shrinking.

Above is to identify whether the machine is available method, ready to re-use, be sure to check carefully, so as to ensure the efficiency of work.