Hot shrinkage machine common problem solving method!

2018-12-30

1. In the process of packaging production, the film material is easy to be offset and cannot be fed normally, which will make the hot shrinkage packaging machine cannot normally carry out the hot shrinkage packaging of objects. Then, the film roll position and tension balance bar can be adjusted.If the upper film material deviates from the clamping chain, the upper triangular plate can be adjusted clockwise;The following film material deviates from the clamping chain, and the upper triangular plate can be adjusted counterclockwise.In this way, the problem of failure can be solved.

2. Thermal shrinkage packaging machine in the packaging production, the packaging part heating slowly or can not hit the standard packaging temperature (more than 160 degrees Celsius), the emergence of this problem can make the packaging can not achieve the expected packaging purpose.Heating process depends on heater, should check heater main power supply circuit first, the circuit of heater is main power supply line passes a magnet absorption switch to reach electric heat pipe again, should detect each contact point of magnet absorption switch first so whether normal.The above phenomenon occurs when the circuit does not pass through one of the phases.If the magnetic switch is normal, the meter can be checked again to see whether the phase and the ohm value of the machine is the same.Short circuit if normal.If all phases are connected but the circuit or electric heat pipe is still abnormal, the heater shall be replaced.

3. On many objects cluster packaging, equipment cannot detect wrapped object, when packing, damage to the packaging to make the packaging work, appear this kind of circumstance is because, heat shrinkable packaging machine in the cluster packaging affected the magic eye detection of objects in the middle of the gap, only need to heat shrinkable packaging machine electric eye detection Angle adjustment for bevel, avoid the generation of the above phenomenon.

   The above three kinds of faults are common failures in the application of hot shrinkage packaging machine in the production line. We hope that the solutions we provide to you can better help you use and produce, so as to better improve the production efficiency, reduce packaging losses, and improve the competitiveness of the product market.