Eight things you need to know about thermal shrinking machine

2019-03-27

Thermal shrinkage machine is a lot of people seldom come into contact with the things in life at ordinary times, can say basically can't use, but for industrialized production workers, thermal shrinkage machine but has very big effect. Although some are used every day in their, but thermal shrinkage machine has eight knowledge needed to know, you know a few?

1.Thermal shrinking machine because of the consumption of large power, so the power input power must be greater than the nominal power of the shrinking machine, or easy to burn the circuit or electrical components.

2.The machine must be attached to the ground for personal safety.

3.Each machine is attached with a power cable at the factory, and the terminal lead part with the power identification symbol must be connected correctly.

4.When the machine specified voltage for three phase 380V power supply, must be input at the same time, otherwise the machine can not work normally, and easy to burn internal electrical parts.

5.The machine must be installed horizontally, otherwise it will shorten the service life of the electric heat pipe.

6.When the machine is used for more than three months continuously, the heat-resistant wire of the shrinkage chamber shall be inspected and replaced according to its aging degree.

7.When the machine works, the operator's palm and other parts are not allowed to contact with the operation of the machine parts, especially the contraction of the indoor temperature is very high, it is easy to burn.

8.After the packaging work, the heating switch should be turned off to allow the conveying motor and fan motor to continue running for about 10 minutes, and then cut off the whole power supply.

The above is the thermal shrinking machine eight knowledge, do not know the people to learn quickly. These are very important, also must pay attention to the use of methods and installation requirements